We have the parts for your ideas!
ServoCity- Servos & Accessories- Hitec Servos- HS-322HD Standard Deluxe-

HS-322HD Standard Deluxe

 

51 oz-in.

 

0.15 sec/60°

The key to the great performance and durability of the HS-322HD servo is linked to its Karbonite geartrain and one peice circuit board. Karbonite gears are nearly 4 times stronger than nylon gears and provide virtually wear-free performance. The HS-322HD servo is also the most powerful servo under $10! Great gears, great electronics and a great price equal a great servo.

Servo Angle Schematic 180 3.8

This servo can operate 180° when given a pulse signal ranging from 600usec to 2400usec. Since most R/C controllers cannot generate this wide of signal range, you will need to use our servo stretcher for 180° operation.

Detailed Specifications

Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.19sec/60° at no load
Operating Speed (6.0V): 0.15sec/60° at no load
Stall Torque (4.8V): 42 oz/in (3.0 kg/cm)
Stall Torque (6.0V): 51 oz/in (3.7 kg/cm)
Current Drain (4.8V): 7.4mA/idle and 160mA no load operating
Current Drain (6.0V): 7.7mA/idle and 180mA no load operating
Dead Band Width: 5usec
Operating Angle: 40 Deg. one side pulse traveling 400usec
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Motor Type: Cored Metal Brush
Potentiometer Drive: 4 Slider/Direct Drive
Bearing Type: Top/Resin Bushing
Gear Type: Heavy Duty Resin
360 Modifiable: Yes
Connector Wire Length: 11.81" (300mm)
Dimensions: See Schematics
Weight: 1.52oz (43g)

Price:

$9.99

Part:

33322S

Status:

 

Rotation:

Direction:

Qty:

Standard Servo Schematic 2

A = .780” (19.82mm)
B = .530” (13.47mm)
C = 1.33” (33.79mm)
D = .400” (10.17mm)
E = .380” (9.66mm)
F = 1.19” (30.22mm)
G = .460” (11.68mm)
H = 1.05” (26.67mm)
J = 2.08” (52.84mm)
K = .368” (9.35mm)
L = .172” (4.38mm)
M = 1.57” (39.88mm)
X = .120” (3.05mm)

Copyright 1999-2008 Robotzone. LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.