PC Servo Programmer

ServoCity - Electronics & Accessories - PC Servo Programmer

Welcome the the world of high performance servo technology. Using this HMI PC Servo Programmer and servo tester, you can set the parameters in our new line of digital robot servos (only servos that are HSR units). View the function chart below to see all the programming function you can set using this programmer. Connects to your serial port. If you are using a laptop and do not have a serial port, you can use a USB to Serial Port adaptor.


	NOTE: This programmer will not run servos for animation or for motion routines. If you are needing a controller run motion routines you need the 8-SCB controller.


	Functions: Reset to factory defaults Set overload protection settings Set resolution modes Set the deadband width Set the direction of rotation Increase/Decrease rotation speed Fail Safe on/off Set the endpoint of each servo Set the neutral point of each servo Automatic servo movement test program


	Works with the following servos: HSR-8498HB HSR-5990TG HSR-5980MG HSR-5498SG

Price:

$24.99

Part:

78206

Status:

Qty:


	Be sure to check out our new Servo Protractor (angle tester). Works perfect for setting up multiple digital servos to the same angle.


	Copyright 1999-2008 Robotzone. LLC. - All Rights Reserved ServoCity is a registered trademark of Robotzone, LLC.